Casablanca Fan Company 86UxxM BLADE/BLADE Holder Installation, Installing the Switch Housing CAP

BLADE/BLADE HOLDER INSTALLATION

Step 12. Using the blade holder screws(pack of 11) attach each blade/bladeholder assembly to the motor.

Using the screwdriver, tighten securely by hand only.

Blade holder

screws(2 per blade)

SWITCH HOUSING BRACKET/ CAP HARDWARE

		switch housing
	switch housing bracket	mount Screw
		(removed in step 10)
	(2)
		8-32 X 3/8″
switch housing cap		(2)

INSTALLING THE SWITCH HOUSING BRACKETS

Step 13. Take the 2 switch housing brackets and snap them into place in the holes in the switch housing. This is to prevent any wires getting pushed down near the motor. Make sure no wires are in the way or pinched in these brackets.

INSTALLING THE SWITCH HOUSING CAP

Note: If you have purchased an accessory light fixture for this fan, please go to Step 16. if not, please continue with

Step 14.

Step 14. Line up the two clearance holes in the cap with the two threaded holes on the raised rim of the switch housing. Press the cap onto the switch housing to seat the guide pins into the alignment holes of the switch housing.

Step 15. Using the two (2) 8-32 X 3/8″ screws removed in Step 10, install the cap onto the switch housing.

Tighten securely by hand only.

8