Casablanca Fan Company 86UxxM Remove Dummy Switch Housing & Shipping Block, Wilderness

Wilderness™

REMOVE DUMMY SWITCH HOUSING & SHIPPING BLOCK

Step 10. To reach the blade holder mounting holes in the fan motor the switch housing cap must be removed. Take out the two 8-32 X 3/8” screws securing the switch housing cap and remove. Put the two (2) screws aside for the moment, they will be used in Step 15 to install the switch housing cap after the blades are installed.

Note: Save these two screws–they will be used in Step 15!

switch housing CAp	switch
mount Screw	housing
8-32 X 3/8”	Cap
(2)

BLADE & BLADE HOLDER HARDWARE

BLADE	BLADE
	HOLDER
BLADE SCREW	BLADE HOLDER
AND WASHER	SCREW
(4 PER BLADE)	(2 PER BLADE)

BLADE BADGE INSTALLATION

Step 11. Attach each blade to a blade holder by first press- ing the blade badge into the blade, then installing the blade holder using the four blade screws provided for each blade.

Using a screwdriver tighten securely by hand only.

Repeat for each blade assembly

BLADE

HOLDER

BLADE SCREW and washers (4 PER BLADE)

BLADE

7