Remove Dummy Switch Housing and Shipping Blocks
Step 8.To reach the blade holder mounting holes in the fan motor, the dummy switch housing must be removed.
Take out the two
TIP: Rotate the motor beneath the switch housing plate to access the shipping block screws through the hole in the switch housing plate.
Step 9. Unscrew and remove the five shipping blocks. Retain the five screws for use in Step 11b to install the blade/blade holder assembly. You can discard the shipping blocks. The shipping blocks are only used when shipping the fan.
IMPORTANT!
Retain the five screws removed in Step 9 for use in Step 11b.
Dummy Switch
Housing
Shipping
Block
Hole in Switch
Housing Plate
Blade Badge Installation
Blade Hardware (not to scale)
|
| Screw Pack C: | Screw Pack D: |
Blade Badge (5) | Blade Holder (5) | Medallion Nails (20) Blade Badge Screws (21) | Blade Holder Screws (6) |
|
|
|
|
Attach Blade Holders
Step 10. Using Screw Pack C and the provided screwdriver, carefully align the Medallion Nail on the front of the blade badge and install the screw. NOTE: The front of the blade badge is the side with the beadboard. Tighten securely by hand. Repeat three more times per blade badge. And repeat for each blade badge. (Check installation to make sure that the Medallion Nails are aligned straight.)
warning!
Do not use electric screwdriver to tighten blade screws. Hand tighten using a manual screwdriver only.
Front of Blade
8