AT&T AT3111-2 user manual Belt clip & optional headset, Installation, Removal

Getting started

Belt clip & optional headset

Install belt clip as shown below if desired:

Installation

Snap belt clip	IC:xxxxX-xxxxxxxx FCC ID: XXxxx-xxxx-xx	IC:xxxxX-xxxxxxxx FCC ID: XXxxx-xxxx-xx
into notches
on both sides
of handset.

Removal

Pull and unlock one flap from the notch first before detaching the whole belt clip from handset.

For hands-free telephone conversations, use any industry standard 2.5mm headset (purchased separately). For best results, use a AT&T 2.5mm headset.

NOTE: If the sound quality of the headset is not satisfactory, try unplugging it, and firmly plugging it in again.

Plug the 2.5 mm headset into the jack on the side of the handset (beneath the small rubber flap).

HANDSET 1