Getting started
Telephone base and charger installation
We recommend that you install the telephone base away from any electronic equipment and appliances such as personal computers, computer routers, television sets, microwave ovens, and refrigerators. Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base and the charger as shown below. Make sure that the electrical outlet is not controlled by a wall switch.
Telephone base installation
1.Plug the small end of the larger power adapter into the power jack at the bottom of the telephone base.
MANUFACTURED IN CHINA
COMPLIES WITH 47 CFR PART 68
REGISTRATION NO.:
RINGER EQUIVALENCE: 0.1B
USOC JACK: RJ11C/RJ11W
HAC | FCC ID: |
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1) THIS DEVICE MAY NOT CAUSE HARMFUL INTER- FERENCE; AND 2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUD- ING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. PRIVACY OF COMMUNI- CATIONS MAY NOT BE ENSURED WHEN USING THIS PHONE.
DC 6V 300mA
CLASS 2 POWER SOURCE ONLY
TELEPHONE
EQUIPMENT
2.Plug one end of the telephone line cord into the telephone jack at the bottom of the telephone base.
3.Route cords through slots.
5.Plug the large end of the larger power adapter into an power outlet not controlled by a wall switch.
Power adapter
Telephone
line cord 4. Plug the other end of the telephone line cord 
into a telephone jack.
DSL filter (not included)
Charger installation
NOTES:
1.Plug the small end of the smaller power adapter into the jack on the underside of the charger, then route the cord through the slot as shown.
2.Plug the large end of the smaller power adapter into an electrical outlet.
1. Use only the power adapter supplied with this product or equivalent.
2.This power unit is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling or an under-
3.If you receive high speed internet service through your telephone line (commonly referred to as DSL), and you are experiencing interference during conversations and/or your caller ID features aren’t functioning properly, install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.
