Casablanca Fan Company Casablanca Brescia Gallery Edition owner manual Test Program, FAN Operation

IMPORTANT OPERATING NOTES

Turning On Your Fan: The fan will not receive any signals for the first 20 seconds after power on. This allows the electronics to warm up and stabilize.

Power Failure: The remote control is not affected by house- hold power failure as it is battery operated. Once power is restored to the fan it will receive an auto-update signal from the remote control within 30 minutes after power is restored. All previously set modes and functions will be restored to the fan.

Button Operation: Rapid button pressing causes erratic fan operation. For reliable operation of the remote control and fan you must wait ONE SECOND between button presses to allow the radio signal to be transmitted to the fan and received.

Labeling: If you have more than
one Comfort•Touch fan in your
home, we suggest you put an ad-
hesive room identification label
on the back of the control. La-
bels are in the remote control	SPACE FOR LABEL
package.

General: Your Comfort•Touch remote control uses one of 15 different radio signals to control the fan. This channel is set at the factory. There may be times when the channel needs to be changed,i.e.:

•Two fans in the house set to the same causing interference.

•Two fans are to be operated from one control.

•Two controls are to operate the same fan - see special 'Dual Remote Control' section on the next page.

TEST PROGRAM

Press the button to activate a two minute program that puts the fan through a complete functional test. The test starts with a full screen display, then the 'preset' chan- nel number before going into a full light, fan and reverse exercise. Follow the remote control LCD display and com- pare it to the actual fan operation to confirm correct operation.

FULL LCD

SCREEN

DISPLAY

TEST

BUTTON

W-21

TEMPERATURE

FAN OPERATION

The Comfort•Touch fan is controlled by the remote control.
The fan is turned on and off by alternate pushes of the large
right hand button. As with all button operations, an audio
tone sounds with each push. With the fan on, the control
display will indicate an up or down moving arrow that shows
direction and places a box around the operating speed. The			AIRFLOW
two small	and	buttons below the fan button increase	DIRECTION

or decrease speed once for each press.

FAN

ON/OFF

BUTTON

SPEED

UP/DOWN

BUTTONS

FAN SPEED

LIGHT OPERATION

The light is turned on and off by alternate pushes of the			LIGHT
large left hand button. When on, the display will indicate			ON/OFF
the light bulb symbol and a vertical segment display repre-			BUTTON
senting brightness. When the light is on, the brightness may
be changed by using the small	and	buttons below the	LIGHT
light button. Pressing and holding either button will change
			UP/DOWN
the brightness continuously.			BUTTONS

Bulb-Saver Feature

When the light is turned on, the brightness is gradually in- creased until it reaches the preset level. This feature helps extend light bulb life.

ADDITIONAL CONTROL FEATURES

BRIGHTNESS

INDICATOR

Additional control program features are available from the con- trol panel by opening the control panel door. To activate a control function press the appropriate button; the display will indicate that the program is running.

In some cases you can run more than one program at once, such

as and and the display will indicate that they are both activated. In other cases one program will override another

as the two programs can not run together i.e. and . Full details are explained in the sections that follow.

CONTROL PANEL

DOOR

CONTROL

PANEL

16