3Connecting the Pedal

Figure 8

Pedal plug

Clip J

Position the pedal plug as shown in Figure 8 and insert it into the pedal connector on the bottom of the piano. Secure the pedal cable to the upright of the stand using the J clips that you installed when assembling the stand (Figure 8).

4Connecting to a Power Supply

Caution

The screws that you use to assemble the stand may become loose after a long period due to changes in temperature and humidity, or vibration caused by normal use, etc. Periodically check the screws used to fasten the stand and the butterfly bolts used to fasten the stand and the piano, and tighten them whenever necessary.

Attachment of the Score Stand

Install the music stand by inserting its pegs into the holes in the top of the piano.

Figure 9

Power cord

Household wall outlet

1.Check to make sure that the piano’s POWER button is in the OFF position. If it is ON, press the button to switch it OFF.

2.Attach the power cord that comes with the piano to the bottom of the piano.*

3.Plug the piano’s power cord into a wall outlet (Figure 9).

*2: applies to the AP-31V and AP-33V

IMPORTANT!

The shapes of the piano’s power cord and wall outlet should be different according to countries or regions. The illustrations are examples.

With the AP-31 and AP-33, the power cord is hard-wired to the bottom of the instrument.

427B-E-033B

AP31/33_E_26_30.p65

Page 29

E-29

03.10.22, 5:05 PM Adobe PageMaker 6.5J/PPC