Assembly Instructions

• Illustrations in this User’s Guide shows the AP-31.

Caution

Take particular care to avoid injury when installing legs and pedals, and when mounting the keyboard onto the stand.

When assembling, make sure that the sliding keyboard cover of the piano body is completely closed. If the cover is left open during assembly, it may close sud- denly causing the fingers to be pinched between the piano body and cover.

1Assembling the stand

Refer to Figures 3, 4 and 5 as you assemble the stand according to the following procedure.

Figure 3

F

 

 

I E

 

 

G

 

I

 

 

 

 

 

 

 

 

C

F

 

 

L

I

J

A

 

E

 

 

 

 

L *

I *

IMPORTANT!

Be sure to assemble the stand on a flat surface.

This stand does not include any of the tools required to assemble it. You should have a large Phillips head (+) screwdriver on hand for assembly.

Figure 1

A

B

C

x2

E

 

 

 

 

 

 

x2

F

 

 

 

x4

G

Bottom

D

 

H

B

 

 

G

 

3

Side upright

 

x1

H

 

x14

I

 

x2

J

 

x2

K

D

x2

L

Check the items that come with the unit to make sure that everything shown in Figure 1 (A through L) is included. All screws are in a plastic bag inside of the packing card- board.

Figure 2

12

Before starting actual assembly of the stand, undo the clip at location 1 (Figure 2) where the pedal cable comes out the back of crosspiece D. Pull out the coiled cable and re- fasten two clips at points 1 and 2 as shown in the illus- tration.

4

Crosspiece

5

1.Attach E brackets to side uprights A and B using the I screws (Figure 3).

When attaching the E bracket to the side upright B, slip a J clip onto the I screw before screwing the I screw into the upright at point 3.

2.Attach angle brackets F to side uprights A and B using the four I screws (Figure 3).

3.Install height adjustment screw H into hole 4 located in the center of the back of crosspiece D (Figure 3).

4.Attach side uprights A and B to crosspiece D using the four G screws (Figure 3).

Make sure that crosspiece D is correctly positioned as indicated by 5 in the inset of Figure 3. It should be per- pendicular (at a 90-degree angle) to the two side uprights. Also make sure that uprights A and B are parallel with each other. If the pieces are not positioned correctly, the nuts built into crosspiece D will not seat properly with the G screws. This can result in stripping of the threads and free turning of nuts.

427B-E-031A

E-27

AP31/33_E_26_30.p65

Page 27

03.10.22, 5:05 PM Adobe PageMaker 6.5J/PPC