.To charge using a USB connection to a computer
The battery loaded in the camera is charged whenever the camera is connected directly to a computer with the USB cable.
•Depending on the setup of your computer, you may not be able to charge the camera’s battery over a USB connection. If this happens, use of the
1.Turn off the camera.
Check to make sure that the camera’s monitor screen is blank. If it isn’t, press [ON/OFF] (Power) to turn off the camera.
|
| [ON/OFF] (Power) | |
|
| Monitor screen | |
2. With your computer | USB port | USB cable | |
turned on, connect the | (included with camera) | ||
| |||
camera to it. |
|
| |
The back lamp should light | Large connector | ||
red, indicating that charging | |||
|
| ||
has started. |
|
| |
The back lamp will go out |
|
| |
when charging is complete. |
|
| |
It takes about 130 minutes to |
| [USB/AV] port | |
achieve a full charge. |
| ||
|
| ||
Charging may take longer |
|
| |
depending on charging |
|
| |
conditions. |
| Small connector | |
|
| ||
| Making sure that the | mark on the USB cable | |
| connector is towards the lens side, connect the | ||
| cable to the camera. |
|
IMPORTANT!
•The first time you connect the camera to your computer with the USB cable, an error message may appear on your computer. If this happens, disconnect and then reconnect the USB cable.
16 | Quick Start Basics |
|