
Determines the fixed value (C) of an inviscid fluid (steady flow, incompressible fluid) when the flow velocity (v), location (height) (z), specific weight ( ρ), and pressure (P) are known.
| C = | 1 | v2+ | P | + gz |
|
| |||
| 2 |
| ρ | |
|
|
|
| |
Determines the difference in elevation (h) from the transit to the leveling rod after a transit is used to read the length on the leveling rod (
) between the upper and lower stadia lines, and the angle of elevation (Ƨ).
| h = | 1 | K sin2θ + Csinθ (K and C: stadia constants, 0° < Ƨ < 90°, > 0) | ||
2 | ||||
|
|
| ||
|
|
| Units: : m, Ƨ: ° (degrees), h: m | |
Determines the horizontal distance (S) from the transit to the leveling rod after a transit is used to read the length on the leveling rod (
) between the upper and lower stadia lines, and the angle of elevation (Ƨ).
cos2 θ+ Ccosθ (K and C: stadia constants, 0° < θ < 90°,
> 0)Units:
: m, Ƨ: ° (degrees), S: m


Program Mode (PRGM)
You can use the PRGM Mode (,g) to create and store programs for calculations you need to perform on a regular basis. You can include any calculation that can be performed in the COMP, CMPLX, BASE, SD, or REG Mode in a program.
kProgram Mode Overview
A Specifying a Program Run ModeThough you create and run programs in the PRGM Mode, each program has a “run mode” that it runs in. You can specify COMP, CMPLX, BASE, SD, or REG as a program’s run mode. This means you need to think about what you want your program to do and select the appropriate run mode.
A Program MemoryProgram memory has a total capacity of 680 bytes, which can be shared by up to four programs. Further program storage is not possible after program memory becomes full.