Note that you cannot input a Bsymbol if you are using 6mm wide tape.
∙The Label Printer automatically adjusts the character size whenever you de- lete a Bsymbol to change a
Initial Size | Size After Delete of B |
AUTO | 2×2 |
To change the character size
Example: To input “ABXYZ” as 2×2 characters.
1. Input the text.
2. Press SIZE to display the current character size
Text Effects
There are three text effects that you can assign: shading, underlining, and boxed text. The following shows examples of each.
Shading:
Underlining:
Boxed Text:
setting.
AUTO
Text effect changes are applied to printed text only. The appearance of the displayed text does not change, but the text effect indicators will show you when a text effect is being used.
Important!
3. Use Hand Jto change the displayed size in the following sequence.
AUTO 1× 1 1× 2 1× 3 2× 1 2× 2 2× 3
2× 3 2× 2 2× 1 1× 3 1× 2 1× 1 AUTO
4. When the character size you want to specify is | XYZ | |
on the display, press SET to select it and return | ||
to the text display. | ||
|
Note
∙You could also perform the above procedure in reverse, specifying the char- acter size first and then inputting the text.
∙Any text effect specification you make is applied to all the characters on the display. You cannot make multiple specifications for specific characters.
∙Underlining and boxed text may overlap with some characters.
∙Due to overlapping of the two effects, underlining is not visible if you use it in the same line as boxed text.
To specify a text effect
1.Input the text.
2.Press EFFECT to display a menu of text effects.
| Normal (no effects) |
|
|
|
|
|
| – |
|
|
| Box | |||
|
|
|
|
|
|
|
| ||||||||
| Shading |
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
| Cursor |
|
|
|
|
|
|
|
| Underline | |||||
|
|
|
|
|
|
| |||||||||
|
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
| |||||
3. | Use Hand Jto move the cursor to the effect you want to use. | ||||||||||||||
4. | When the cursor is located under the effect you |
| |||||||||||||
| want to specify, press SET to select it and re- |
|
turn to the text display. | XYZ |
|
Note
∙You could also perform the above procedure in reverse, specifying the text effect first and then inputting the text.