Part 8 Reference
This section contains information about the Label Printer that you can use as reference when you need it.
Cleaning the Printer Head and Roller
A dirty printer head and roller can result in poor printing quality. If you have problems with print quality, use the following procedure to clean the printer head and roller.
To clean the printer head and roller
1.Make sure the Label Printer is turned off.
2.Turn over the Label Printer, and open the back cover while pressing down on its lock.
3.Slide the printer head release in the direction
indicated by the arrow, and remove the tape cartridge.
4.Use a cotton swab dipped in alcohol to clean the printer head and roller as shown in the illustration.
Printer head
Roller
5. Replace the tape cartridge and close the back cover.
E-14
Initial Power On Settings
The following are the initial settings of the Label Printer whenever you turn it power on.
Item | Power On |
Display | Cleared |
SIZE | AUTO (2×2) |
EFFECT | CANCEL |
MIRROR | OFF |
6mm | OFF |
Initializing the Label Printer
If you experience serious malfunction of the Label Printer or if operation fails completely, try performing the following operation to initialize the printer.
Important!
∙Initializing the Label Printer deletes all memory contents. Make sure you have a
To initialize the Label Printer
1. | Turn power off. |
|
2. | While holding down the PRINT and ESC keys, |
|
| press ON/OFF to turn power on. |
|
3. | Keeping PRINT and ESC held down, release | INT? |
| the ON/OFF key only. | |
4. | Release PRINT and ESC keys. | |
∙ This prompt confirms whether or not you want to | ||
initialize the Label Printer.
5.Press SET to initialize the Label Printer or ESC to abort the reset operation. ∙ The following table shows the initial settings.
Item | Reset |
Display | Cleared |
Memory | Cleared |
SYMBOL | , |
SIZE | AUTO (2×2) |
EFFECT | CANCEL |
MIRROR | OFF |
MEMO | STR? |
DENSITY | 3 |
6mm | OFF |