Assembling the Stand

PREPARATION

•Before starting assembly of the stand, divide the polystyrene foam packing material L into the sections as shown in the illustration below. After dividing up the material, you should end up with a total of six pieces named L-(a), L-(b), and L-(c), which you will use while assembling the stand.

•If you do not have any packing material available for some reason, use a magazine or some other thick item.

L-(b)

L-(c)

L-(a)

• Pull the pedal unit cable out from the pedal unit F.

F

1. Place the digital piano onto the two L-(a)foam pieces.

Bottom of the digital piano

Bracket

*

L-(a)

 

L-(a)

*Make sure that the edges of the brackets on either side of the digital piano are positioned at the top of the foam pieces.

2.Perform the following steps to attach side panel A to the digital piano.

IMPORTANT!

•When inserting the corner of the side panel into the bracket on the side of the digital piano in step (2-3) below, take care to avoid damaging the side panel corner (). Never try to insert the side panel into the bracket without first tilting the side panel at an angle as instructed in step (2-2). Doing so creates the risk of damage of the side panel corner.

(2-1) On side panel A, locate the corner that has a metal piece attached to it, and then insert that corner into foam piece L-(b).

(2-2) Tilt side panel A slightly as indicated by the arrow in the illustration.

(2-3) Keeping side panel A tilted at an angle, carefully insert the opposite corner () into the bracket on the side of the digital piano.

(2-1)(2-3) (2-2)

Bracket

A

L-(b)

E-28