Assembling the Stand

3. Keeping side panel A tilted at an angle, align the side panel with side of the digital piano.

(3-1) Push side panel A in the direction indicated by the black arrow in the illustration to align the side panel so there is as little space as possible between its top edge A and the bottom of the top panel of the digital piano ().

(3-2) After alignment is complete, stand side panel A straight up so it is firmly against the side of the digital piano.

Top panel of the digital piano

(3-2)

A

L (3-1) -(b)

IMPORTANT!

•When performing step (3-1) above, make sure that you position side panel A so its top edge reaches the bottom of the digital piano top panel. If it does not, you will not be able to stand side panel A straight up in step (3-2).

4. Perform the following steps to secure the side panel to the digital piano.

(4-1) Press downwards on side panel A to ensure that it is inserted as far as it will go into the bracket on the side of the digital piano.

(4-2) Use the D screws to secure side panel A to the digital piano.

(4-1)(4-2)

D

Bracket

A

5. Insert foam piece L-(c)under side panel A as shown in the illustration.

A

L-(c)

IMPORTANT!

•The foam piece should be located directly under the two screw holes () in the side panel.

6. Repeat steps 2 through 5 to attach side panel

B to the other side of the digital piano.

7.Attach back panel C to side panels A and B. Use the four screws D and four joint connectors K.

•Insert the four joint connectors at the four locations on back panel C. The holes in the joint connectors should be aligned with the holes in the back panel.

•Lift up back panel C so its screw holes align with the screw holes in the side panels, and then tighten the screws D.

•If you have trouble inserting the screws D into the joint connector K holes, use a screwdriver to rotate the joint connector ( in Figure).

*CAUTION

•Never try to force the screws! Forcing the screws D to turn while the joint connector K holes are not aligned correctly can strip the screw threads.

•Partially tighten the screws on one side of the Back panel C and then fully tighten the screws on the other side.

•Next, fully tighten the screws that you partially tightened.

 

K

 

K

B

D

 

 

 

A

English

C

D

E-29