Part-1 QUICK START OPERATION

Options: Roll paper ••• P-5880T

4.Loading paper roll

Mode switch to REG

CAL

REG X

OFF

Z

RF

6 Remove the printer cover by lifting up

5 Remove the journal paper from the

the back.

take-up reel.

 

 

printer cover

 

 

 

PGM

1. To load journal paper

1Pressing down the printer open key.

2Open the platen arm.

platen arm

3Ensuring the paper is being fed from the bottom of the roll, lower the roll into the space behind the printer.

4Put the leading end of the paper over the printer.

5Close the platen arm slowly until it locks steadily.

7Roll the paper onto the take-up reel a few turns.

8Set the left plate of the take-up reel and place the reel into the register.

9Press the lkey to take up any slack in the paper.

0Replace the printer cover slowly.

2. To remove journal paper

1Remove the printer cover by lifting up the back.

2Press the lkey until approximately 20cm of the paper is fed from the printer.

3Cut off the roll paper.

4Remove the take-up reel from the printer and take off the left plate of the reel.

6Press the printer open key and open the platen arm.

7Remove the core of the paper.

8Load new paper following the instruc- tions “1. To load journal paper”.

Default printer definition is journal printer. To print receipts, please refer to 1-7-3 on page 24 to switch the printer for receipt or journal.

To load receipt paper

1In case of defining the printer as receipt printer, follow steps 1 through 5 of “To load journal paper”.

2Pass the leading end of the receipt paper through the paper outlet of the printer cover.

3Tear off any excess paper.

To remove receipt paper

1In case of defining the printer as journal printer, follow steps 6 through 7 of “To remove a journal paper”.

Caution(in handling the thermal paper)

1.Never touch the printer head and platen.

2.Unpack the paper just before your use.

3.Avoid heat/direct sunlight.

4.Avoid dusty and humid places for storage.

5.Do not scratch the paper.

6.Do not keep the paper under the following circumstances: High humidity and tempera- ture/direct sunlight/contact with glue, thin- ner or a rubber eraser.

E

10