Casio XJ-H1600, XJ-H1650, XJ-ST145, XJ-ST155 Error Indicators and Warning Messages

Error Indicators and Warning Messages

Warning messages and indicators let you know what the problem is when a projector error occurs. When an error occurs, wait until the fan stops before unplugging the AC power cord. If you unplug the AC power cord while the fan is still operating, an error may occur when you plug the AC power cord back in.

Indicator/Error Message		Description and Required Action
POWER	: Green steady	The projector’s internal temperature is very high. Press the [ESC] key to
LIGHT	: –	clear the warning message and perform the following steps.
		1 Check for any blocking of the projector’s vents, and make sure that
TEMP	: –
		there is sufficient space around the projector. See “Setup Precautions”
Message	: Internal temperature is too	in the “Setup Guide”.
		2 If there is dust accumulated around the vents, turn off the projector and
	high. Check projector air
	vents for blockage.	remove it. See “Cleaning the Projector” (page 40).
POWER	: Amber flashing J	Power has turned off automatically due to internal overheating. Perform
	Amber steady	the following steps.
LIGHT	: –	1 Check for any blocking of the projector’s vents, and make sure that
		there is sufficient space around the projector. See “Setup Precautions”
TEMP	: –
		in the “Setup Guide”.
Message	: Internal temperature is too	2 If there is dust accumulated around the vents, remove it. See “Cleaning
	high. The projector will	the Projector” (page 40).
	turn off.	If there is no problem with the projector’s vents, confirm that the POWER/
		STANDBY indicator is lit amber (without flashing), and then turn power
		back on again. If the error occurs again when you turn power back on,
		contact your retailer or nearest authorized CASIO Service Center.
POWER	: Amber flashing J	Power has turned off automatically due to a fan problem. Confirm that the
	Red steady	POWER/STANDBY indicator is lit red (without flashing) and that the fan
LIGHT	: Red steady	has stopped. After checking the POWER/STANDBY indicator, disconnect
		the power cord from the projector and wait for all of the projector’s
TEMP	: Red steady
		indicators to go out. Next, reconnect the power cord and turn projector
Message	: There is a problem with	power back on.
		If the error occurs again when you turn power back on, contact your
	the fan. The projector will
		retailer or nearest authorized CASIO Service Center.
	turn off.
POWER	: Amber flashing J	Power has turned off automatically due to a system problem. After
	Red steady	confirming that the POWER/STANDBY indicator is lit red (without
LIGHT	: –	flashing), disconnect the power cord from the projector and wait for all of
		the projector’s indicators to go out. Next, reconnect the power cord and
TEMP	: Red steady
		turn the projector back on.
Message	: A system problem has	If the error occurs again when you turn power back on, contact your
		retailer or nearest authorized CASIO Service Center.
	occurred. The projector
	will turn off.

41