Using a Manual Connection Profile for Wireless LAN Connection between the Data Projector and One or More Computers

First Wireless LAN Connection between the Data Projector and Four Computers

The following procedure uses the initial default settings of the Manual Connection 1 connection profile to establish wireless LAN connections between the Data Projector and four computers for the first time.

Important!

zThe XJ-S35/YP-100 does not have manual connection initial values registered. Before performing the following procedure, use the procedure under “Sending Settings from a Computer to the Data Projector” (page 34) to send Manual Connection 1 profile settings from your computer to the projector.

zYou should use Wireless Connection 2 on all of the computers connecting to the Data Projector. Do not use an older version of Wireless Connection.

To change the Data Projector connection profile to Manual Connection 1

1 Turn on the Data Projector and connect the CASIO YW-2 wireless adapter to the Data Projector’s USB port.

2

3

zThis will start up Wireless automatically and display the “Standing by for connection...” message on the projection screen.

On the Data Projector’s remote controller, press the […] key.

zThis will cause the connection profile menu to appear in the projection area.

Press the [T] key three times to move the highlighting to “Manual Connection 1” and then press the [ENTER] key.

zThis will display a connection profile change confirmation dialog box.

4 Presskey. the [S] key to move the highlighting to “Yes” and then press the [ENTER]

zThis will close the confirmation dialog box and return to the “Standing by for connection...” message.

zNext, perform the procedure under “To establish a wireless LAN connection with Manual Connection 1 between the first computer and the Data Projector” below.

11