Switching the Data Projector Connection Profile
The Data Projector uses one of its six connection profiles to connect to a computer over a wireless LAN. You can use the following procedure to switch the connection profile as required.
To view the Data Projector’s current connection profile information
1 While Wireless is shown in the projection area, press the [FUNC] key on the Data Projector’s remote controller.
zThis will display the Wireless function menu.
zThe contents of the Wireless function menu will differ according to the operational status of the Data Projector when you press the [FUNC] key. The above example shows the menu when the [FUNC] key is pressed while “Standing by for connection...” is displayed in the projection area.
2 Check to make sure that “View Connection Info” is selected and then press the [ENTER] key.
zThis will display the connection information window, which shows the currently selected profile and the settings of the profile.
(Simple Connection Profile)
(Manual Connection Profile)
3 To close the connection information window, press the [ESC] key of the Data Projector’s remote controller.
Note
You can also view the Data Projector’s current connection profile information using the Web Setup top page. For more information, see “To display and log into the Web Setup page” (page 20).
23