To turn connection keyword input on or off on the Data Projector
1 While Wireless is shown in the projection area, press the [MENU] key on the Data Projector’s remote controller.
2
3
4
5
zThis will display the setup menu.
Press the [T] key to move the highlighting to “USB” and then press the [ENTER] key.
Press the [T] key once to move the highlighting to “Setup” and then press the [ENTER] key.
zThis will display the Wireless setup menu with “Connection Keyword” highlighted.
Use [X] and [W] to select “On” or “Off”.
zSelecting “On” will require connection keyword input whenever a computer tries to connect to the Data Projector.
To exit the Wireless setup menu, press the [ESC] key.
To connect to the Data Projector from a computer over a wireless LAN when connection keyword input is required
1 On the computer, perform the required operation to connect to the Data Projector.
zTo do this, perform the procedures under “Using a Manual Connection Profile for Wireless LAN Connection between the Data Projector and One or More Computers” (page 11).
2 | On the Wireless Connection 2 window, click the | button. |
| z This will display a dialog box for inputting a connection keyword. | |
3 Enter the connection keyword that is preset for the Data Projector and then click the [OK] button.
zIf the input connection keyword is correct, a wireless LAN connection will be established between the Data Projector and computer and the computer screen contents will be sent to the Data Projector.
zThe connection keyword you input will be cleared if it does not match the one that is assigned to the Data Projector.
zIf you input the wrong keyword three times in a row, the connection keyword input dialog
box will not appear again when you click the [OK] button on the error dialog box. To
display the connection keyword input dialog box again, click the 
button.
28