Creating a Computer Connection Profile

After you modify the settings of the Data Projector’s manual setting profile, you will also need to modify the existing wireless LAN connection settings (connection profile) of the computer accordingly, or you will have to create a new connection profile. This section explains the procedure for using Wireless Connection 2 to create a new profile or to modify the existing profile of a computer.

To create a new computer connection profile

Note

This procedure shows how to create a new computer connection profile to match modifications made in the settings of the Data Projector’s connection profile named “Manual Connection 3”. In this example, the projector’s name (page 26) is “Projector A”.

1 Perform the procedure under “To modify Data Projector manual connection settings” (page 29) to modify Data Projector’s “Manual Connection 3” profile settings as shown below.

Dialog Box Item

Setting

Profile Name

RoomB

 

 

SSID

ROOM_B

 

 

Access Mode

Ad Hoc

 

 

Security Setup

WEP

 

 

WEP Key Format

ASCII/128bit

 

 

WEP Key/WPA/WPA2 Pass Phrase

1234567890abc

 

 

DHCP

Off

 

 

IP Address

192.168.10.1

 

 

Subnet Mask

255.255.255.0

 

 

Default Gateway

0.0.0.0

 

 

Channel

Auto

 

 

zThe above settings are provided as an example only. When you are establishing a wireless LAN connection using the Access Point Mode, you need to configure settings to match the actual access point. When configuring the IP address of the Data Projector (and the computer connecting to the Data Projector over the wireless LAN connection), you need to make sure that the IP address of the access point is different from all other IP addresses within the same network.

zFor details about each of the settings on the dialog box, see “Manual Connection Setting Reference” (page 40).

30