To change the Web Setup login password

1 On the initial Web Setup page, click the [Change Password] button. z This will display the change password page.

2 In the “Current Password” box, enter the current password (“casio” if you have not yet changed the initial default password) and then enter the new password into the “New Password” box.

zA password must have at least four single-byte characters and it can be up to 16 characters long.

3 Input the new password again into the lower “New Password” box. 4 Click the [Change] button.

zIf you input all of the required information correctly, your password will be changed and the Web Setup top page will reappear.

Enabling and Disabling Web Setup

This section explains how you can disable the Web Setup page so it is not displayed. You can disable the Web Setup page when you want to restrict access to Web Setup while there are multiple computers connected to the Data Projector.

To enable and disable Web Setup

1 While Wireless is shown in the projection area, press the [MENU] key on the Data Projector’s remote controller.

2

3

4

5

6

zThis will display the setup menu.

Press the [T] key to move the highlighting to “USB” and then press the [ENTER] key.

Press the [T] key once to move the highlighting to “Setup” and then press the [ENTER] key.

zThis will display the Wireless setup menu.

Press the [T] key to move the highlighting to “Web Setup”.

Use [X] and [W] to select “Enable” or “Disable”.

zSelecting “Disable” will make it impossible to access the Web Setup page from any computer.

To exit the Wireless setup menu, press the [ESC] key.

22