How to assemble GBF PRO RECUMBENT BIKE (2)

ENG

7Installing the console

Remove the 4 screws on the back of the console.

Insert the cable connector which extends from the bracket into

the cable inlet on the back of the console.

Caution Insert the cable connector firmly as far as it will go. If it is not inserted properly and the contact is poor, the console will not function.

Secure the console to the bracket with the removed screws.

Attach the connector on the steering post to that on the bracket. Important Conceal the excess cord inside the steering post.

Console

Cable

Bracket

connecter

Steering post

8Connecting the controller

Insert the speed sensor cable plug (light blue) which extends from the steering post into the “S” jack on the controller.

Install the brake button onto the steering assembly. Insert the cable plug (yellow) into the “B” jack on the controller.

Important Wind excess brake button cord around the steering assembly.

Insert the connection cable plug into the “H” jack on the control- ler. Insert the straight plug on the other end of the cable into the jack on the bottom of the steering unit.

10Installing the seat handle

Place the seat handle in position on the rear of the seat base and

securely tighten the “seat handle installation screw set” (2 screws).

Caution Make sure to install the seat handle with the ends of the handle pointing upward.

Installation angle

Seat handle installation screws

Nut

Flat washer

11Installing the seat cushion

Install the two “seat cushion A installation screws” on either side of the back of the seat cushion A (seat) and temporarily tighten the two screws.

Secure the side of the cushion on which the screws were tempo- rarily tightened to the top of the seat base.

Install the remaining two screws and tighten all four screws to securely fasten the cushion.

Seat cushion A installation screw/flat washer

Seat cushion A

Flat washer

Brake button

Connection cable

Cable from the steering post

Brake button cable

Connection cable

Seat cushion A installation screw

Place the seat cushion B

(backrest) in position with

Seat cushion B

the screw holes on the back

 

of the seat base aligned; se-

 

curely tighten the “seat cush-

 

ion B installation screw set”

 

(4 screws).

 

Steering unit

9Installing the seat base

Remove the tapping screw from the end cap and then remove the end cap from the back end of the seat rail.

Remove the stopper from the side of the rail.

Insert the main unit rail while raising the seat slide adjustment lever.

Replace the stopper and end cap in their original positions.

End cap

Stopper

Seat base

Tapping screw

Seat rail

Seat slide adjustment lever

Seat cushion B installation screw

R washer

12Installing the pedals

Use the provided special tool to securely fasten the pedals to the crank, as shown in the figure.

Be sure to identify R and L of the pedal with the engraved mark.

Fasten clockwise the R pedal, and counterclockwise the L pedal.

 

 

Front

Special tool

L

R

 

 

4

Page 4
Image 4
Cateye GB-300R Installing the console, Connecting the controller, Installing the seat handle, Installing the seat cushion