ENG
How to Select a Program
You can switch the exercise program in sequence during training by pressing the 
button.
1. Manual (P-1)
•This is the most common program. You set the load level by pressing the 
and 
buttons.
•You can exercise at the constant load level.
2. Program modes (P-2 to P-6)
•You can view the profile of the changes in the selected load levels by pressing the 
button.
•You can change the load levels of the profile by pressing the 
or 
button.
3. HR control mode (P-7 to P-11)
Important: In order to exercise in the HR control modes, you need the optional chest belt heart rate sensor (the chest belt heart rate sensor by Polar can also be used).
•The target heart rate is calculated from the maximum heart rate, and load is automatically increased and decreased to maintain the heart rate during training.
•The target heart rate is the rate of the load to the maximum heart rate for each age is
displayed in %. You can switch the 5 levels, from 50% to 95% of the maximum heart rate
by pressing the 
button.
At this time, the heart mark is displayed on display.
•By entering your age, you can select a target heart rate suitable for your purpose.
*The maximum heart rate is calculated by “220 - age.”
Daily inspection
Be sure to perform the following daily inspection before using the product.
Be sure the seat cushion is tight.
Move the seat cushion from side to side. Be sure the cushion is tight.
If it is loose, use the 13 mm wrench to securely tighten the seat cushion A (seat) and B (backrest) installation screws with a torque of 19.6 Nm (200 kgf/cm).
Be sure the pin of the seat slide adjustment lever has been inserted securely.
If anything is abnormal, contact CAT EYE or the dealer from whom the product was purchased.
Be sure that the steering unit has been securely fixed to the steering post.
If it is loose, use the L wrench to securely tighten the steering unit installation screws (4) with a torque of 19.6 Nm (200 kgf/cm).
Be sure the seat handle is tight and not loose or rattling.
Move the seat handle from side to side. Be sure there is no excessive play.
If it is loose, use the L wrench to securely tighten the seat handle installation screws (2) with a torque of 19.6 Nm (200 kgf/cm).
Be sure the pedals are securely attached to the crank.
If a pedal is loose, securely tighten it.
Be sure there is no left, right, front, or rear looseness of the main unit.
If the main unit wobbles, securely tighten the
Be sure there are no cracks or other abnormalities of the main unit frame or other components.
If anything is abnormal, contact CATEYE or the dealer where the product was purchased.
10
