Using your Extractor
For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking.
To switch on the extractor and set the speed level
•Touch key A. The appliance will switch on at the first speed level.
•To increase the speed level touch key B. The speed cycles through first, second and third speed levels, and the relevant number indicator will show on the centre of the display.
•To switch the extractor off, touch key A.
The extractor lights
•To switch the lights on touch key D. The extractor lights will cycle through three light settings (high, medium, low, off) with each touch of the key. The light indicator will show on the centre of the display when the lights are on.
The intensive function
•The extractor is equipped with an intensive function which runs for ten minutes before returning to the previous selected speed level.
•To activate the intensive function, touch and hold key B at any speed level for approximately five seconds. The 3 indicator on the centre of the display will flash whilst the intensive function is on.
•To cancel the intensive function, touch the speed level key and the extractor will return to the previous speed level.
The timer
•The extractor is equipped with a timer that allows the extractor to run for 15 minutes before switching off automatically.
•To activate the timer, touch key E. The timer indicator will show on the centre of the display when the timer is on.
Please note
The timer cannot be activated when the intensive function is on.
The clean air function
•The extractor is equipped with a clean air function that switches on the motor for ten minutes every hour at speed level one.
•To activate the clean air function, touch key A for five seconds when the appliance is off. When the motor is running, the light indicator will flash and the first speed indicator will light up. For the remaining 50 minutes, the light indicator will flash.
•To cancel the clean air function, touch any key except the light key.
The ambient light function
•The extractor is equipped with an ambient light function that switches on the LED lights on the side of the extractor.
•To switch the ambient light function on or off, touch and hold the timer button for approximately five seconds
Control Panel
A – Power key
B – Speed level key C – Light indicator D - Light key
E – Timer key
Fig. 1
A
B
C
D
E
2
