44
ADVICE FOR THE INSTALLER
Important
Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS and in compliance with the local safety standards.
•Failure to observe this rule will invalidate the warranty.
•Always disconnect the appliance from the electrical supply before carrying out any maintenance operations or repairs.
•The walls surrounding the oven must be made of
•Taking care NOT to lift the oven by the door handle.
WARNING
When correctly installed, your product meets all safety requirements laid down for this type of product category.
However special care should be taken around the rear or the underneath of the appliance as these areas are not designed orintended to be touched and may contain sharp or rough edges, that may cause injury.
Installation
Important
–You need the following housing area to fit your oven correctly.
–The double oven is designed to fit into a cabinet of 600 mm width.
–The double oven can be built in the kitchen units, but you must ensure that it is properly ventilated.
–In the diagram the appliance is ventilated by means of the space in the top of the kitchen cabinet.
–Lift the appliance into position onto the shelf, taking care NOT to lift it by the door handles.
–Remember the housing should not be free standing but be secured to the wall and/or adjacent fittings.
WARNING
–We would point out that the adhesive which bonds the plastic laminate to the furniture must withstand temperatures not less than 150° C to avoid delamination.
–The appliance must be housed in heat resistant units.
–The walls of the units must be capable of resisting temperatures of 75 °C above room temperature.
