CDA HVC65 manual How to Install the Hob, How to install the hob

How to Install the Hob

How to install the hob:

Overall dimensions of the hob:

Worktop cut-out dimensions:

HVC65 width 590mm depth 510mm HVC75 width 770mm depth 510mm

HVC65 width 560mm depth 490mm HVC75 width 740mm depth 490mm

1.Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance. The cut-out (Fig.12) shows a 60mm gap from the wall to the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear wall or splashback is 50mm.

2.Position the hob seal, as shown in (Fig.14), ensuring that the ends meet without overlapping. Do not use silicone type sealant.

3.Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in (Fig.15). Remove any excess sealant after tightening the brackets. Do not over-tighten the fixing brackets.

	60mm
	480mm	650mm
	400mm
	560mm
	740mm
190mm	190mm
Fig.12	Fig.13
	3cm	4cm
Fig.14	Fig.15

14