LIGHTING THE BURNERS
In order to light the burner, you must:
1 – Press in the corresponding knob and turn
position marked by the 
symbol (fig. 6) and hold the knob in until the flame has been lit.
In the case of a mains failure light the burner with a match or lighted taper.
2 – Wait about ten seconds after the gas lighting before releasing the knob (starting time for the valve).
3 – Adjust the gas valve to the desired power.
Important
If the burner flame should go out for some reason, the safety valve will automatically stop the gas flow.
To
If your local gas supply makes it difficult to light the burner with the knob set to maxi- mum, set the knob to minimum and repeat the operation.
Figure 6
9
