CDA RC 9020 Electronic clock fig, Normal cooking without the use of the programmer

Electronic clock (fig. 5)

The programmer is equipped with an electronic clock with lighted numbers which indicate hours and minutes.

Upon immediate connection of the oven or after a blackout, three zeroes will flash on the programmer panel.

To set the hour it is necessary to push

the button and then the or button until you have set the exact hour (fig. 5).

Alternatively, simultaneously push the

two buttons and at the same

time push the or button.

Note: Setting the clock deletes any programme.

Normal cooking without the use of the programmer

To manually use the oven, that is, without the aid of the programmer, it is necessary to cancel the flashing AUTO by pushing

the button (AUTO will be switched off and the symbol will go on - Fig. 6).

Attention: If the AUTO is not flashing (which means a cooking programme has already been inserted), by pushing the

button you have cancelled the programme and switched to manual.

Electronic timer

The timer programme consists only of a buzzer which may be set for a maximum period of 23 hours and 59 minutes.

If the AUTO is flashing push the button.

To set the time, push the button

and the or until you obtain the desired time (fig. 7).

Having finished the setting, the normal time will appear on the panel and the symbol will appear.

The countdown will start immediately and may be seen at any moment on the panel by simply pressing the button .

At the end of the time, the symbol will be switched off and an intermittent buzzer will go off; this can be stopped by pressing any one of the buttons.

Altering the audible signal

By pressing the button you can choose from three variations.

Fig. 6

8

A

U

T

O

Fig. 7