46
Conversion to Natural Gas or to LPG
Injectors Replacement of Top Burners
Every cooker is provided with a set of injectors for the various types of gas. Injectors not supplied can be obtained from the
Select the injectors to be replaced according to the table at page 47.
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each injector.
To replace the injectors proceed as follows:
–Remove the pan supports, the burner caps and flame speaders.
–Using a wrench, substitute the nozzle injectors “J” (figs. 44 - 45) with those most suitable for the kind of gas for which it is to be used (see “Table for the choice of the injectors”).
The burners are constructed in such a way so as not to require the regulation of the primary air.
Auxiliary, |
|
|
|
|
|
| |
|
| J | |
and Rapid |
|
| |
|
|
| |
|
|
| |
burners |
|
|
|
|
|
|
|
|
|
|
|
Fig. 44
Triple Ring burner
J
Fig. 45
Adjusting of the Minimum of the Top Burners
Considering that in the minimum position the flame must have a length of about 4 mm and must remain lit even with a quick turn from the maximum position to that of minimum.
The flame adjustment is done in the following way:
–Turn on the burner
–Turn the tap to the MINIMUM position
–Take off the knob
–With a thin screwdriver turn the screw “F“ until adjustment is
correct (fig. 46).
Normally for LPG, tighten up the regulation screw.
F
Fig. 46
