CLEANING AND SANITIZING
Sanitizing: All sanitizing agents in the food zone must comply with 21 CFR 178.1010.
All food dispensing units should be sanitized periodically. All parts to be sanitized must be cleaned first.
To prepare a sanitizing solution:
Add 2 Tsp. Of Liquid Clorox Bleach (5.25% Concentration) To 1 gallon Of Water At Room Temperature (70°- 90°F).
Note: Always start with a unopened bottle of Clorox Bleach since the solution from an opened bottle has a short life span.
•Soak all parts for a minimum of 3 min. in the sanitizing solution.
•Let all sanitized parts drain and dry naturally. DO NOT WIPE THEM DRY.
•Before using the sanitized unit (or parts) with food stuffs, rinse all parts thoroughly with water.
Water pipe connecting and fixtures directly connected to a potable water supply shall be sized, installed, and maintained in accordance with Federal, Sate, and Local
Cleaning
1.Turn the power switch to OFF.
2.Remove the drip tray with grill and empty the contents.
3.Wash and let dry the tray and grill (use a mild dishwasher detergent).
4.Wash and let dry the dispense area.
5.Turn the power switch to ON.
Cleaning the Hoppers (See Hopper Illustration section VI)
1.Open the cabinet door and raise the top cabinet lid.
2.Take the hopper out of the cabinet.
3.Pull off the elbow chute and remove the hopper cover.
4.Unscrew the auger gear CW while holding steady the auger inside the hopper. Take out the auger, agitator wheel, and spring.
5.Rinse each item thoroughly.
6.Let dry all items and reassemble.
Filling the Hoppers
1.Open the cabinet door, raise the top cabinet lid.
2.Fill each hopper with the correct product. Note: Hoppers can also be removed for filling.
3.Reposition hoppers in the hopper compartment, making sure the hoppers are properly seated.
Flushing the Whipper Chamber
1.Open the cabinet door and turn the RINSE switch to ON.
2.Place a container under each dispense nozzle and push the dispense switches.
Note: On manual dispense machines, push and hold the dispense buttons for 10 seconds.
3.Open the cabinet door and turn the Rinse switch back to OFF.
4.Wash and let dry the splash panel.
5.Remove the drip tray, wash and let dry thoroughly.
Removing and Cleaning the Cappuccino Whipper Chambers (See Hopper Illustration section VI)
1.Remove the dispense cap by pulling it forward and at the same time twisting it clockwise.
2.Grab and pull the mixing bowl out of the mixing bowl socket.
3.Grab and twist the whipping chamber clockwise and pull it off the mounting plate.
4.Pull the Whipper blade off the motor shaft. Notice the flat keyway on the shaft and the matching keyway inside the Whipper blade shaft. It is important that these two keyways are lined up when
5.Twist the mounting plate clockwise and pull it off the motor shaft.
6.Slip off the
Removing and Cleaning the Coffee/Tea Mixing Chambers (See Hopper Illustration section VI)
1.Remove the dispense cap.
2.Pull the mixing bowl out of the mixing bowl socket.
3.Take out the extension tubes.
4.Rinse them thoroughly
10
