
MAINTENANCE
To Replace The Picture / Duratran GB w/ Metal Doors Only: Lift up the two end tabs on top of door with a pointed object
or flat head screwdriver.
Pull the entire picture frame out. Open up the two clear panels and replace picture.
Tuck clear plastic panel inside bracket at top.
Be sure to tuck clear panel under bracket before sliding frame ass'y inside door. The longer metal tab side goes in the front.
To Replace The Fluorescent Bulb:
Remove the upper inside door panel. Turn the lamp and pull it out of the lamp holder, then place the new lamp into the lamp holder and turn it until it snaps into position.
To Replace The Starter:
Remove the upper inside door panel, turn the starter slightly
RECOMMENDED PREVENTIVE MAINTENANCE
1.Check All Chamber Mounts For Signs Of Wear A. Product Running Down The Front Of The Unit.
B. Product Built Up On The Back Of Chamber Mount. Remove Chamber Mount.
Clean And
2.Clean Out Vent Motor, Trough And Tubing. Lift up black tabs, remove Trough Drawer, Clean, and replace Trough Drawer.
Remove Hose Assembly From The Motor. Clean Out And Replace.
3)Check All Dispense Valves For Lime
Remove The Valves And Clean.
( You Can Take These Valves Apart By Hand As Shown). Replace The Assembly As Needed (L467A).
Replace The Valve Into The Tank And Refill tank.
9
DURATRAN
FRAME ASS'Y
DURATRAN
BULB TYPE
F8T5/CW
LAMP HOLDER
STARTER TYPE
STARTER BASE
BALLAST
WATER FLOW ADJUSTMENT