FOLDING and STORING continued
Playard/Crib
1To remove floorboard:
• Unfasten attachment straps.
• Remove floorboard and set aside.
2 To unlock and raise floor:
• Push down on center of Playard/Crib floor.
• Lift Floor Handle and rotate in direction of arrow (counterclockwise).
• Pull up on Floor Handle to raise floor.
Raise approximately 45.7 cm
(18 inches).
4 Gather Playard/Crib frame together | Floor Loop |
while pulling up on Floor Loop. |
|
5Wrap floorboard around
Playard/Crib frame with padding facing in.
NOTE: Floorboard Handle MUST be aligned with wheels as shown.
Handle
6 Secure Attachment Straps:
Floor
Handle
3To fold top rails:
• Pull up on top rail slightly.
• Squeeze Release Button on bottom of top rail and push rail down. (Release buttons are identified by printed arrows.)
Repeat for other sides.
•Bottom - Thread Attachment Strap through Leg Loop then through Floorboard Loop and fold back onto itself.
•Middle and Top - Thread
Attachment Straps through remaining floorboard loops and fold back onto themselves.
Attachment
Straps
NOTE:
•If rails are difficult to unlock, raise center of floor higher and squeeze Release Button again.
•If only one side of rail folds, squeeze Release Button again to fully fold.
Release 
Button
Floorboard Loop
7Position travel bag over Playard/Crib so Handle comes through Opening in side of bag.
Pull travel bag over Playard/Crib.
Pull Floor Loop through opening on top of travel bag.
Leg Loop
Floor Loop
Opening
NOTE: To prevent rubbing, | Handle |
make sure travel bag is |
|
positioned above wheels. |
|
8
