Tether Storage, Tether Hook Edge of Car Seat Back

❃Tether Storage

DO NOT anchor tether strap to the vehicle when using car seat rear-facing.

Tether hook must be attached to car seat for rear-facinguse.

For storage of tether hook:

•Lift seat pad from top of car seat.

•Attach tether hook to back of car seat using one of the locations shown.

•Pull loose end of strap to remove any slack.

•Roll loose end of strap up and secure with a rubber band.

•Re-attach seat pad.

Tether Hook

Tether Hook Storage

See Instructions

Image 23

Contents

Avoid injury or death Read and understand this manual Table of Contents Registration Information Important InformationPage Page Basic Information Rear-facingBirth to 30 lbs .6 kg Height & Weight LimitsPreterm or Low Birth Weight Infants Outgrowing Car Seat Fig. a Opening Pull to tighten FORWARD-FACING Installation Overhead Shield Models Only Placing Child in CAR Seat Placing Child in CAR Seat Buckle Point Models Overhead Shield Adjustment fig. bHarness Straps fig. a Harness Tie Upper For Toddlers Changing Harness Strap SlotsForward-facing Must use top slots Point Models fig. e For Infants or Small Toddlers Loop Splitter Plate Top Loop Bottom Vehicle Seat Belts Seat Crease Belts Forward of Seat Crease Flip Lap Belts Manually AdjustableLap Belts With Retractor Passive Restraint Lap or Shoulder Belt Mounted on Door Passive Restraint Lap Belt with Motorized Shoulder Belt Pull Combination Lap/Shoulder Belt with Sliding Latch PlateCombination Lap/Shoulder Belt with Locking Latch Plate Locking Clip Additional Information Installation of Anchor Hardware Back of Car Seat Tether StorageTether Hook Edge of Car Seat Back Removing Overhead Shield Pad Care & CleaningRemoving Seat Pad Buckle Seat Pad and Overhead Shield PadHarness Straps Shell Second Hand Car Seat Aircraft UsePage Call US First