Century Bravo manual Harness Straps fig. a, Harness Tie, Overhead Shield Adjustment fig. b

OPERATIONS and ADJUSTMENTS

1Harness Straps (fig. a):

•To tighten: Pull lower belt tab.

•To loosen: Pull and hold upper belt tab while pulling harness straps.

2Harness Tie:

•To open: Press tab and pull apart.

•To close: Snap halves together. Make sure harness tie is locked by pulling out on each half.

3Overhead Shield Adjustment (fig. b):

•To adjust shield: Push in both buttons and rotate shield to desired position closest to child.

IMPORTANT: DO NOT use position three (3) with rear-facingchildren.

NOTE: Shield does not need to contact child when in closest position; harness system restrains child.

10

4Buckle:

5-Point Models

•To buckle: Insert both tongues into buckle. Pull up on tongues to be sure they are locked.

•To unbuckle: Press red button and pull tongues out of buckle.

Overhead Shield Models

•To buckle: Push tongue into opening. Pull up on tongue to be sure it is locked.

•To unbuckle: Press red button and lift shield over top of car seat.

5Recline:

Recline - Rear-facingonly

Semi-upright - Forward-facing only

Upright - Forward-facing only

To adjust: Pull recline handle out and rotate car seat to desired position, then release handle (fig. c).

6Level Adjuster (Rear-facing only):

4 Positions to adjust to vehicle seat angle:

To adjust: Squeeze handle and rotate car seat to position ball in green zone, then release handle (fig. d).

IMPORTANT: Level adjuster must be in position 1 when used forward-facing with car seat in semi-upright or upright positions.