ASSEMBLY continued
Swivel Locking Tabs
To attach swivel locking tabs:
• Pull Bellow away from swivel Post on front leg.
• Align grooves on Locking Tab with grooves on Post.
• Slide Locking Tab over Post until it snaps in place.
Repeat for opposite leg.
Front Wheel Assembly
To attach front wheel assembly:
• Hold wheel assembly upright.
• Tilt stroller slightly back and push wheel assembly onto leg until it locks in place.
Repeat for opposite leg.
CAUTION: Pull on wheel assemblies to check that they are locked in place.
Footrest
To attach footrest:
• Snap footrest onto stroller frame and push up.
• Push footrest against legs, then slide footrest down until it snaps onto
Cross Tube.
• Check to be sure tabs on bottom of footrest are snapped onto Cross Tube.
Rear Support Frame for Canopy
To secure rear support frame for canopy:
• Rotate canopy forward until it stops.
•Check to be sure
Rear Support Frame is locked in place.
If Rear Support Frame is not locked, pull forward until it locks.
Rear
Support Frame
Cup Holder
To attach cup holder:
• Snap one end of cup holder over stroller frame above canopy.
• Rotate down to opposite side and snap in place.
WARNING
•To avoid burns, never put hot liquids in cup holder.
•Avoid possible tipping, DO NOT place more than 3 lbs. (1.4 kg) in cup holder.
Tray Shield
Tray Shield included with some models.
Tray Shield
To attach tray shield:
• Hook “A” Tabs under tray. | C B A | A B C |
• Push “B” Tabs until they snap onto bottom of tray.
• Push front of shield at “C” Tabs until they snap onto front of tray.
Cross Tube | 4 |
|
