Inspire Electric Fireplace
Fireplace Dimensions
Minimum Shelf Height | 36” | |||
(To Heater Main body) | (914 mm) | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
24����”
(615 mm )
23���"
(594 mm)
| 35�����” (910 mm) |
|
| 5�����” |
|
|
|
|
|
|
| Minimum |
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| 9���” | ||||
[Heater Main Body Width 32���” (832 mm)] | (145 mm) |
|
|
| ||||||||
|
|
|
|
|
| (250 mm) | From Floor | |||||
|
|
|
|
|
|
|
|
|
| |||
Electrical Specifications
Voltage | 120V ac, 60 Hz | |
Total Amps | 7.9 Amps | |
Total Watts | 1050W | |
Heater Rating | 2 x | 500W |
Illumination | 2 x | 20W Low Energy Bulb |
Electrical Connection
A 15 amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fireplace will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes standard with a 6 ft. (1.8 m) long three wire cord, exiting the left side of the fireplace. Plan the installa- tion to avoid the use of an extension cord. Extension cords are for temporary use only. If an extension cord must be used, it must be UL/CSA certified, rated at 15A (1875W), 125V maximum with 14 AWG minimum and constructed of two current carrying conductors with ground. A heavy duty extension cord with the shortest length possible for the connection is recommended and must not be longer than 50 ft. (15.2 m). Do not coil or cover the extension cord.
WARNING
Always confirm that the electrical outlet wiring is in compliance with all applicable local and national building codes and electrical code requirements to avoid the risk of fire or electric shock.
If the fireplace should be exposed to water, imme- diately turn off the main power supply and remove the power plug from the outlet. Never use the fire-
place until it has first been inspected if any portion of it has been exposed to water. Always utilize a qualified service technician to inspect the fireplace and to replace any electrical system components that may have been damaged by water.
Grounding Instructions
This heater is for use on 120 volts. The cord has a plug as shown at A in Figure 1. An adapter as shown at C is available for connecting
A
|
| Cover of |
Grounding Pin |
| Grounded |
B | Outlet Box | |
|
| |
| C |
|
Adapter |
| Metal Screw |
|
| |
| Grounding Means | FP1636 |
|
|
Fig. 1 Grounding methods.
4 | 10009472 |
