Installation Step 7
Install the Lights and the Lenses
•Install a 75 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately
•If the bulbs burn out prematurely due to vibration, replace them with "Garage Door Opener" bulbs.
•Slide lenses into guides as shown. Snap bottom tabs into lens slots.
•For convenience, the lenses may be installed after Adjustment Step 4 on page 26.
•Reverse the procedure to remove the lenses.
Lens Tab
75 Watt Max.
Light Bulb
Lens
Guide
75 Watt Max.
Light Bulb
Lens Slot
Lens Tab
Installation Step 8
Attach the Manual Release
Rope and Handle
|
| Overhand |
|
| Knot |
Trolley |
| Trolley |
| Rope | Release Arm |
|
| |
|
| Manual |
| Overhand | Release Handle |
|
| |
| Knot |
|
WARNING
Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall. Use the manual release only to disengage the trolley and, if possible, only when the door is closed.
Garage doors are heavy. If the door is open when the handle is pulled, the door could close inadvertently if it is not properly balanced. Serious injury may result to persons under the door. Make sure the doorway is clear of persons and obstructions before pulling handle when door is open.
•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.
The knot should be at least 1" from the end of the rope to prevent slipping.
•Thread the other end of the rope through the hole in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot .
If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
15