WARNING

An unbalanced garage door might not reverse when required and someone under the door could be seriously injured or killed.

If your garage door binds, sticks or is out of balance, call for professional garage door service. Garage doors, door springs, cables, pulleys, brackets and their hardware, are under extreme tension and can cause serious injury or death. Do not try to loosen, move or adjust them yourself!

Ropes left on a garage door could cause someone to become entangled and killed. Remove all ropes connected to the door before installing and operating the opener.

Identify the type and height of your door, any special conditions that exist, and any additional materials that may be required, by referring to page 4.

SECTIONAL DOOR

CAUTION

To avoid damage to the garage door and opener, disable locks before installing and operating the opener. Use a wood screw or nail to hold locks in the "open" (unlocked) position.

Operation at other than 120V 60 Hz will cause opener malfunction and damage.

Test your Door

Before you begin, complete the following test to make sure your door is balanced, and is not sticking or binding:

•Lift the door about halfway as shown. Release the door. It should stay in place, supported entirely by its springs.

•Raise and lower the door to see if there is any binding or sticking.

ONE-PIECE DOOR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Safety Reversing Sensor

 

 

 

Installation Hardware

 

 

 

 

 

 

 

 

 

Installation Hardware

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Lag Screw 1/4 x 1-1/2" (4)

 

 

Hex Screw 5/16"-18 x 7/8" (4)

Screw 6AB x 1" (2)

 

 

Hex Screw #8 x 3/8" (2)

 

Insulated Staples (10)

 

 

Hex Screw 1/4-20 x 1-1/2" (2)

 

 

Lag Screw 5/16"-18 x 1-7/8" (4)

 

Ring Fastener (3)

 

 

Carriage Bolts 1/4" - 20 x 1/2" (4)

 

 

Carriage Bolt 5/16"-18 x 2-1/2" (2)

 

Handle

 

 

Screw #10 - 32 x 3/8" (4)

 

 

Clevis Pin 5/16" x 2-3/4" (1)

 

Dry Wall Anchors (2)

 

 

Lock Nut 1/4" - 20 (4)

 

 

Clevis Pin 5/16" x 1" (2)

 

Rail Grease

 

 

Lock Nut #10 x 32 (4)

 

 

Nut 5/16" - 18 (6)

 

Rope

 

 

Wing Nut (2)

 

 

Lock Washer 5/16" (6)

 

 

 

 

 

Insulated Staples (20)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3