Chamberlain 1280 - 1/2 HP All, "Smart, Model 81LM, on the Same Remote, Garage Door Opener, (With "Smart" Button), Single Function Remote Control, To Change the Selected Push Button

Receiver & Remote Control Programming

NOTICE: To comply with FCC rules, adjustment or modification of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the transmitter battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Your garage door opener receiver and remote control transmitter have been set at the factory to a matching code. The door will activate when the remote control push button is pressed.

Your "Smart" garage door opener will operate with:

•up to four "Smart" remote control transmitters (with green indicator lights),

•a Keyless Entry System, and

•code switch remote controls with red indicator lights.

Below are instructions for programming your opener to match any additional remotes you may purchase. See available accessories on page 34.

To Add a Single Function Remote Control

1. Press and hold the remote push button (Figure 1).

WARNING

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the door control(s) or remote control transmitter(s).

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Figure 1

Model 81LM"Smart"Single Function Remote Control

2.Then press and release the "Smart" button on the right side panel of the opener, Figure 2. The opener lights will flash once.

3.Release the remote push button.

Now the opener will operate when the remote control push button is pressed.

If you release the remote control push button before the opener lights flash, the opener will not accept the code.

To Change the Selected Push Buttonon the Same Remote

If you decide to use a different remote control button than originally programmed into the opener, you need to erase all the learned codes and reprogram each remote used to operate the garage door opener.

To Erase all Remote Control Codes:

•Press and hold the "Smart" button on the opener panel until the indicator light turns off (about 6 seconds). All the codes the opener has learned will be erased.

•To reprogram, repeat Steps 1 - 3 for each remote control in use.

Code programming instructions are also located on the opener panel.

Green Battery

Indicator Light

Push Button

Figure 2

Garage Door Opener(With "Smart" Button)

1	2			3
	9	1	9	1
	7	3	7	3
	5			5
	KG			KG

"Smart" Indicator

Button Light

29