Motion Sensing On/Off
Prog <Learn>
Push
Bar

Using the Wall-Mounted Door Control

THE SMART CONTROL PANELTM

Press the push bar to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's

opening.

(PROG) Learn Feature

The door control is equipped with a PROG <LEARN> button to assist in learning remote controls to the unit. Press the PROG <LEARN> button once to initiate LEARN mode and the display will show ‘Learn Remote Control - Press Learn Button Again to Confirm’. Press the PROG <LEARN> button a second time and the display will show ‘Learn Mode - Press Remote Control Button to Learn

This door control contains a motion sensing detector that will automatically turn on the light when it detects a person entering the garage.

Light feature

Hour

Minute

Language

LOCK

Degrees (F/C)

LIGHT

Light

Button

Remote.’ Press the button of the remote control to be learned and the worklight will blink to confirm the remote control has been learned.

Hour & Minute Feature

HM Press or hold either of these side buttons to increment the hour or minute displayed on the LCD display.

Lock Button

LIGHT

Press the Light button

to turn the opener light on or off. It will not control

(LANG) Language Feature

Press this side button to toggle between the three

the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a

3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

When using the opener lights as working lights, we recommend that you first disable the motion sensor. See Automatic Light Feature, below.

Motion Sensing (Automatic Light Feature): The opener light will turn on automatically when a

person enters the garage. When a person walks in front of the door control, the light will come on

for five minutes, then shut off. This feature works by detecting body heat.

To disable this feature, push the motion sensing button on the side of the door control.

We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if you are working beyond the sensors range.

Lock feature

Designed to prevent operation of the door from LOCK hand-held remote controls. However, the door will

open and close from the Door Control, the Outdoor Key Switch and the Keyless Entry Accessories.

To activate, press and hold the Lock button for 2 seconds.

To turn off, press and hold the Lock button again for

2 seconds. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.

languages - English, French and Spanish.

Degrees F/C Feature

Press this side button to toggle the temperature units between Fahrenheit and Celsius.

Display Contrast Adjustment

Press and hold the light button then push the hour button to increase the contrast or the minute button to decrease the contrast.

27