Installation Step 7

Install the Light and the Lenses

Install the lights

•Install a 75 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately 4-1/2 minutes when power is connected. Then the lights will turn OFF.

•If the bulbs burn out prematurely due to vibration, replace with "Garage Door Opener" bulbs.

Install the lenses

The Force Adjustment Control and Smart Button are located on the back panel.

For convenience, you may wish to install the lens after installation and adjustment procedures are completed.

•Slide each lens into guides. Snap bottom tabs into lens slots.

•Reverse the procedure to remove the lenses.

Lens

Guide

Lens

Tab

Lens

Slot

75 Watt

(Maximum)

Light Bulb

Installation Step 8

Attach the Manual Release

Rope and Handle

Overhand

Knot

Trolley

 

Trolley

 

Rope

Release Arm

 

 

Manual

Overhand Release Handle

Knot

WARNING

Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall. Use the manual release only to disengage the trolley and, if possible, only when the door is closed.

Garage doors are heavy. If the door is open when the handle is pulled, the door could close inadvertently if it is not properly balanced. Serious injury may result to persons under the door. Make sure the doorway is clear of persons and obstructions before pulling handle when door is open.

•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of the rope to prevent slipping.

•Thread the other end of the rope through the hole in the release arm of the outer trolley.

•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.

19