
Installation Step 10
Install the Safety Reversing Sensor
Figures 2 and 3 show assembly of brackets and "C" wrap based on the recommended installation of the sensors on each side of the garage door as shown on page 21.
However, Figures 4 and 5 are variations which may fit your installation requirements better. Make sure the wraps and brackets are aligned so the sensors will face each other across the garage door.
•Fasten the "C" wraps to the mounting brackets having square holes, using the hardware shown in Figure 2.
•Connect each assembly to a slotted bracket, using the hardware shown in Figure 3.
Note the alignment of the brackets for left and right sides of the door.
•Finger tighten the lock nuts.
•Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot holes on both sides of the garage door,
•Attach bracket assemblies with
•Adjust right and left side bracket assemblies to the same distance out from the mounting surface. Make sure all door hardware obstructions are cleared. Tighten the nuts securely.
Figure 2
Mounting Bracket
With Square Holes
"C" Wrap
#10 - 32
Lock Nuts
Screws
Figure 3
1/4 x | |
Lag Screws | (with square shoulder) |
Inside
Garage
Wall
| Mounting Bracket | "C" Wrap |
| with Slot |
|
| Mounting Bracket |
|
1/4" - 20 | with Square Holes |
|
|
| |
Lock Nuts |
|
|
Hardware Shown Actual Size
#10 - 32 x 3/8" | #10 x 32 | 1/4 x |
| 1/4" - 20 x 1/2" | 1/4" - 20 |
Screw | Lock Nut | Lag Screw | Staples | Carriage Bolts | Lock Nut |
Figure 4 | Figure 5 |
|
Alternate Wall Mount | Alternate Floor Mount | |
Inside | Inside | Indicator |
Garage | Garage | |
Wall | Wall | Light |
Mounting Bracket |
| Sensor |
with Slot |
| Mounting Bracket |
Mounting Bracket |
| |
| with Square Holes | |
with Square Holes |
| |
|
| |
"C" Wrap |
| Mounting Bracket |
| "C" Wrap | with Slot |
Sensor |
| Attach with |
Indicator Light |
| concrete anchors |
| (not provided) | |
|
| |
Garage |
| Garage |
Floor |
| Floor |
22