Activate opener with any of the following:
1.The Remote Control: Hold the large push button down until the door starts to move.
2.The Door Control: Hold the push bar down until the door starts to move.
3.The Outside Keylock or Keyless Entry System. (See Accessories.)
When the opener is activated with the safety reversing sensor installed and correctly aligned:
WARNING
Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when door is fully closed.
1.If open, door will close. If closed, the door will open.
2.If closing, the door will reverse.
3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).
4.If the door has been stopped in a partially open position, it will close.
5.If obstructed while closing, the door will reverse.
6.If obstructed while opening, the door will stop.
7.The door will reverse in the closing cycle when the invisible beam is broken. If fully open, the door will not close when the beam is broken. Sensor has no effect in the opening cycle.
Trolley 
Release Arm
Trolley
Manual
Release Handle
(Pull Down) | NOTICE |
|
Manual disconnect
position
To open the door manually:
The door should be fully closed if possible. Pull down on the red manual release handle and lift the door manually. To reconnect the door to the opener, press the Door Control push bar.
If the sensor is not installed or not aligned correctly, you can't close the door from any remote control transmitter. You can close the door with the Door Control, the Outside Keylock, or Keyless Entry, however, if you activate them until down travel is complete. If you release them too soon, the door will reverse.
The opener light will blink for 5 seconds when the safety reversing sensor causes the door to reverse.
The Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. They will turn off automatically after
The lockout feature prevents the trolley from reconnecting automatically. Pull the manual release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To disengage the lockout feature, pull the manual release handle straight down. The trolley will reconnect on the next UP or DOWN operation.
| Trolley |
| Release Arm |
Trolley |
|
Manual |
|
Release Handle |
|
(Pull Down & Back |
|
Towards Opener) | NOTICE |
Lockout position
The Door Control Push Bar
Press to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.
Light Feature: Press the Light button. If the opener lights are off, they will turn on.
If the opener lights are on, (even in the
But if you use the Light button to turn the light(s) on and then activate the opener, the light(s) will turn off after
The Light Feature will not control the opener lights when the door is in motion.
Lock Feature: Designed to prevent operation of the door from portable remote controls. However, the door will open and close from the Door Control push bar and from the Keylock and the Keyless Entry Accessories.
To activate: Press and hold the Lock button for
2 seconds. The push bar indicator light will flash as long as the Lock is on.
To turn off: Press and hold the Lock button again for 2 seconds. The indicator light will stop flashing. Normal operation will resume. The Lock feature will also turn off whenever the "Smart" button on the opener end panel is activated.
32