Chamberlain 8200 1/2 HP owner manual Install the Multi-Function Door Control Panel

Installation Step 6

Install the Multi-Function

Door Control Panel

Locate the door control within sight of the door at a minimum height of 5 feet where small children cannot reach, and away from all moving parts of the door and door hardware.

The multi-function door control is typically attached directly to the wall. For pre-wired installations (as in new home construction) it can be mounted to a standard single gang box. See illustrations.

•Strip 1/4" of insulation from one end of the bell wire. Connect the wire to the two screw terminals on the back of the door control as follows: white wire to 2 and white/red wire to 1. (NOTE: After installation, a green indicator light behind the white translucent cover will indicate proper connection. If not lit, the Lock and Light features will not function (reverse wires to correct).

•Before mounting, remove the white cover by gently pushing both thumbs against the upper corners of the cover on the back side of the door control (see illustration).

•For standard wall mount, mark the wall about 1-1/4" up the centerline from the bottom of the door control. Install a 6ABx1-1/4" self-tapping screw at this point, allowing about 1/8" to protrude from the wall. Slip the lower part of the door control over the screw head and adjust for snug fit. Drill and install the top screw with care to avoid cracking the plastic housing. Do not overtighten. Run the bell wire up the wall and across the ceiling to the opener. Use insulated staples to secure the wire in several places. Be careful not to pierce the wire with a staple, creating a short.

•For pre-wired installations, partially install a 6-32x1" machine screw into the bottom of the gang box, allowing about 1/8" to protrude. Slip the lower part of the door control over the screw head and adjust for snug fit. Install top screw with care to avoid cracking plastic housing. Do not overtighten.

•Connect the bell wire to the opener terminal screws as follows: white to 2 and white/red to 1.

•Replace the cover by inserting bottom tabs and snapping into place. To remove the cover after mounting, gently pry at the top with a paper clip or small flat head screwdriver.

WARNING

DO NOT CONNECT TO LIVE ELECTRICAL WIRING. CONNECT ONLY TO 24 VOLT LOW VOLTAGE WIRES. CONNECTION TO LIVE WIRES OR HIGHER VOLTAGE MAY CAUSE SERIOUS INJURY FROM SHOCK, BURN OR ELECTROCUTION.

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the push button(s) or the remote control transmitter(s).

A moving garage door could injure someone under it. Activate the opener only when the door is properly adjusted, you can see it clearly, and there are no obstructions to door travel.

Outside Keylock Accessory Connections

To opener terminal screws: white to 2; white/red to 1

REMOVE COVER		STANDARD WALL MOUNT
RED WHT
1	2
		LOCK
		LIGHT
		To Replace,
		Insert Bottom Tabs First
PRE-WIRED INSTALLATION

LOCK
LIGHT
To Replace,	24 Volt
Insert Bottom Tabs First	2-Conductor Bell Wire

Hardware Shown
Actual Size
Insulated Staples	Dry Wall Anchors
6ABx1-1/4" Screw	Screw 6-32x1"
Multi-Function Door Control

RED WHT

1 2

Multi-Function

Door Control Panel

Terminal Screws

Door Control

Push Bar

2-Conductor Bell Wire

Lock	LOCK
	LIGHT

Button

Light Button

Right Panel

of Opener

Opener

Terminal Screws

1	2			3
	9	1	9	1
	7	3	7	3
		5		5

KGKG

Antenna

18