Chamberlain 8200 1/2 HP owner manual Receiver and Remote Control Programming

Receiver and Remote Control Programming

Your garage door opener receiver and remote control transmitter have been set at the factory to a matching code. The door will open when you press the LARGE remote control push button. The code between the remote control and the receiver changes with each use, randomly accessing over 100 billion new codes.

Your SECURITY✚ opener will operate with:

•several SECURITY✚ remote controls utilizing up to 8 functions.

•one Keyless Entry System (with SECURITY✚ logo)

Follow the instructions below to program your opener to match any additional remotes you may purchase. See Accessories on page 38.

To Add A Remote Control

If you have a Multi-Function door control:

1. With the door closed, press and hold a button on
	the remote to be programmed. See Figure 1.
2.	Press and hold the Light button on the door control.
3.	Press and hold the door control push bar.
4.	After the opener lights flash, release all buttons.
Test by pressing the remote push button.

To comply with FCC rules, adjustment or modification of this receiver and/or transmitter is prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

WARNING

Children operating or playing with a garage door opener can injure themselves or others. The garage door could close and cause serious injury or death. Do not allow children to operate the door control or remote control transmitter.

A moving garage door could injure or kill someone under it. Activate the opener only when you can see the door clearly, it is free of obstructions, and is properly adjusted.

Figure 1

SECURITY✚

Multi-Function Remote Control

If you do not have a Multi-Function door control:

1.Press and hold a button on the remote to be programmed. See Figure 1.

2.Then press and release the Smart (learn) button on the right panel of the opener, Figure 2. The indicator light on the panel will begin to blink and the opener lights will flash once.

3.Release the remote push button.

Test by pressing the remote push button.

To Erase All Remote Control Codes

Press and hold the Smart button on the opener for

6 seconds. The indicator light will turn on. Release the Smart button when it turns off. All codes are now erased from the opener. Then follow the steps above to re-program each remote control.

To Control the Opener Lights

With SECURITY✚ transmitters, a remote push button can be programmed to operate the opener lights without opening the door.

1.With the door closed, press and hold the remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.Press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

Test by pressing the remote push button. The opener lights should turn on or off but the door should not move.

Model 940CB SECURITY✚ Keyless Entry

Follow instructions on page 38 (Accessories).

Figure 2

1 2 3

Select a

Push Button

SECURITY✚

Garage Door Opener

1		2		3
		9	1	9	1
		7	3	7	3
		5		5
		KG		KG
Smart (learn)	Indicator		RIGHT
Button	Light	SIDE PANEL

33