Using the Wall-Mounted Door Control

To Open the Door Manually

THE MULTI-FUNCTION DOOR CONTROL

Press the lighted push button to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.

LOCK

LIGHT

Lighted

Push Button

Lock

Button

Light

Button

WARNING

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:

• If possible, use emergency release handle to

disengage trolley ONLY when garage door is CLOSED.

Weak or broken springs or unbalanced door could

result in an open door falling rapidly and/or

unexpectedly.

Light feature

Press the Light button to turn the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes.

Lock feature

Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outdoor Keylock and the Keyless Entry Accessories.

•

NEVER use emergency release handle unless garage

 

doorway is clear of persons and obstructions.

•

NEVER use handle to pull door open or closed. If rope

 

knot becomes untied, you could fall.

DISCONNECT THE TROLLEY:

 

The door should be fully closed

 

if possible. Pull down on the

Trolley

emergency release handle (so

 

that the trolley release arm

Trolley

snaps into a vertical position)

Release Arm

and lift the door manually.

(in Manual

Disconnect

The lockout feature prevents

Position)

NOT

the trolley from reconnecting

ICE

 

automatically, and the door

Lockout position

can be raised and lowered

(Manual disconnect)

manually as often as

 

necessary.

 

To activate, press and hold the Lock button for 2 seconds. The push button light will flash as long as the Lock feature is on.

To turn off, press and hold the Lock button again for 2 seconds. The push button light will stop flashing. The Lock feature will also turn off whenever the “learn” button on the motor unit panel is activated.

Additional feature when used with the 3-Button hand-held remote

To control the opener lights:

In addition to operating the door, you may program the remote to operate the lights.

1.With the door closed, press and hold a small remote button that you want to control the light.

2.Press and hold the Light button on the door control.

3.While holding the Light button, press and hold the Lock button on the door control.

4.After the opener lights flash, release all buttons.

TO RE-CONNECT THE TROLLEY:

Pull the emergency release handle toward the opener at an angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote.

 

Trolley

 

Trolley

Emergency

Release

Arm

Release

 

Handle

NOTICE

(Pull at 45° angle)

To reconnect

31