ASSEMBLY STEP 1
Assemble the Rail
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
1.Turn the opened rail carton upside down and empty its contents onto a level work surface.
2.Unfold the rails, taking care to avoid kinking the screw rod joint.
3.Rotate the rail sections so that the flat side is down and the screw side is up for all three lengths. Keep it clean and free of debris while you are working.
Straight
Door Arm
Rail
Support
Braces
Rail Assembly
Carton
Remove | Extend | |
Cardboard | ||
End Rails | ||
Packing | ||
Outward | ||
|
CAUTION
To prevent INJURY from pinching, keep hands and fingers away from the joints while assembling the rail.
Extend | Remove | |
Cardboard Packing | ||
End Rails | ||
Outward |
| |
| Center | |
| Rail |
| Trolley Rack |
Rail Assembly | Chassis Assembly |
Hardware Bag | Hardware Bag |
Sprocket End Rail
NOTE: During assembly, avoid pulling the rail section housing the trolley rack away from the screw rod. The rack is factory set about 9" (23 cm) from the end of the screw rod to the center of the rack.
If the plastic liner slides part way out during assembly, simply push it back in.
Trolley Rack
Door End Rail
Rotate
Center Rail
Rail Sprocket
8