INSTALLING THE BRACKETS

Be sure power to the opener is disconnected. Install and align the brackets so the sensors will face each other across the garage door, with the beam no higher than 6" above the floor. They may be installed in one of three ways, as follows:

Garage door track installation (preferred):
Figure 1

DOOR TRACK MOUNT (RIGHT SIDE)

Door

Track

Lip

Slip the curved arms over the rounded edge of each door track, with the curved arms facing the door. Snap into place against the side of the track. It should lie flush, with the lip hugging the back edge of the track, as shown in Figure 1.

If your door track will not support the bracket securely, wall installation is recommended.

Wall installation:

• Place the bracket against the wall with curved

arms facing the door. Be sure there is enough

Sensor

Bracket

Figure 2

Indicator light

Lens

clearance for the sensor beam to be unobstructed.

• If additional depth is needed, an extension bracket

(see Accessories) or wood blocks can be used.

• Use bracket mounting holes as a template to

locate and drill (2) 3/16" diameter pilot holes on

the wall at each side of the door, no higher than 6"

above the floor.

• Attach brackets to wall with lag screws

(not provided).

• If using extension brackets or wood blocks, adjust

right and left assemblies to the same distance out

from the mounting surface. Make sure all door

hardware obstructions are cleared.

Floor installation:

• Use wood blocks or extension brackets (see

Accessories) to elevate sensor brackets so the

lenses will be no higher than 6" above the floor.

 

WALL MOUNT (RIGHT SIDE)

Inside

Extension

arage

G

Bracket

all

W

(See Accessories)

 

 

(Provided with

 

Extension Bracket)

(Provided with

Sensor

Bracket

Extension

 

Bracket)

Indicator

Lens

light

Figure 3

FLOOR MOUNT (RIGHT SIDE)

Lens

• Carefully measure and place right and left

assemblies at the same distance out from the wall.

Be sure all door hardware obstructions are

cleared.

• Fasten to the floor with concrete anchors as

shown.

Sensor

Bracket

(Provided with

 

Extension

Inside

Bracket)

arage

 

G

 

all

 

W

Indicator

light

(Provided with Extension Bracket)

Attach with concrete anchors (not provided)

Extension

Bracket

(See Accessories)

17