INSTALLATION STEP 8
Install the Lights
•Install up to a 100 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately
•Insert bottom lens tabs into slots on chassis. Tilt towards chassis to engage top tabs, then drop down gently into place.
•To remove, depress both top lens tabs. Tilt lens slightly outward and down, then pull out to clear bulbs. Use care to avoid snapping off bottom lens tabs.
•Reverse the procedure to close the lens.
•If the bulbs burn out prematurely due to vibration, replace with a Garage Door Opener bulb.
NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket.
Top Lens Tab
Lens
Bottom
Lens Tab
Top
Chassis
Slot
Bottom
Chassis Slots
Top
Lens Tab
Top |
|
Chassis Slot |
|
| Lens |
Bottom | Insert Bottom |
Chassis Slot | Lens Tabs First |
INSTALLATION STEP 9
Attach the Emergency Release Rope and Handle
•Thread one end of the rope through the hole in the top of the red handle so "NOTICE" reads right side up as shown. Secure with an overhand knot at least 1" from the end of the rope to prevent slipping.
•Thread the other end of the rope through the hole in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
WARNING
•To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
–If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly.
–NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
•NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
Trolley
Release Arm
Overhand
EmergencyKnot
Release Handle
22