Planning
Identify the type and height of your garage door. Survey your garage area to see if any of the conditions below apply to your installation. Additional materials may be required. You may find it helpful to refer back to this page and the accompanying illustrations as you proceed with the installation of your opener.
Depending on your requirements, there are several installation steps which may call for materials or hardware not included in the carton.
•Installation Step 1 – Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural supports.
•Installation Step 4 – Depending upon garage construction, extension brackets or wood blocks may be needed to install sensors.
•Installation Step 4 – Alternate floor mounting of the safety reversing sensor will require hardware not provided.
•Installation Step 6 – Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware may be required.
•Do you have an access door in addition to the garage door? If not, Model 7702CB Outside Quick Release is required. See Accessories page.
•Look at the garage door where it meets the floor. Any gap between the floor and the bottom of the door must not exceed 1/4". Otherwise, the safety reversal system may not work properly. See Adjustment Step 3. Floor or door should be repaired.
SECTIONAL DOOR INSTALLATIONS
•Do you have a steel, aluminum, fiberglass or glass panel door? If so, horizontal and vertical reinforcement is required (Installation Step 12).
•The opener should be installed above the center of the door. If there is a torsion spring or center bearing plate in the way of the header bracket, it may be installed within 4 feet to the left or right of the door center. See Installation Steps 1 and 12.
•If your door is more than 7 feet high, see rail extension kits listed on Accessories page.
SECTIONAL DOOR INSTALLATION
FINISHED CEILING
Horizontal and vertical reinforcement is needed for lightweight garage doors (fiberglass, steel, aluminum, door with glass panels, etc.). See page 24 for details.
Header Wall
— — | Door |
— | Center |
| |
— — — |
|
— — |
|
Rail
Extension Spring OR Torsion Spring
Door Control
Support bracket & fastening hardware is required.
See page 20.
Motor unit
Access |
| CLOSED POSITION | |
Door | Header | ||
| Rail | Rail | |
| Bracket | ||
| Bracket |
| |
|
|
| |
|
| Torsion | Trolley |
|
| Spring |
|
| Straight | Emergency | |
| Door | Release | |
| Arm | Rope & Handle | |
Safety
Safety
Reversing Sensor
Gap between floor
and bottom of door must not exceed 1/4"
Header | Curved |
Reversing Sensor
Wall | Door | Door | |
Garage | Arm | ||
Bracket | |||
Door |
| ||
|
|
4